|
|
image.png (27,382 bytes) |
|
|
Hi YK, There are two reasons for this. 1. I remember that we had enabled this option before,but there were some build errors in ATV9. 2. In the previous design, SMART3 was turned on through RCU Power key , so there was no special handling of wakeup from CEC. I also check with ATV10. This is no build fails if i enable the CONFIG_CEC_WAKEUP flag. Jerry |
|
|
Hi YK, You can download the test FW form ALT server. /release_by_fxn/smart3_test/Mantis1720/ATV10_SD/usb_bfx-at100_V15.536.33.zip My TV can send CEC message<Routing Change> to turn on SMART3 from passive standby mode. When the flag<CONFIG_CEC_WAKEUP> enabled, you can check CEC message in console output. If you have any question, please let me know. Jerry |
|
|
Hi YK, Have any update about this mantis ? Jerry |
|
|
Hi Jerry This function cannot proceed further due to the limitations of Amlogic SoC. If there is any further discussion, I will reopen it again. I will close this ticket Thank you YK.Jung |
- yk.jung ( (ALTech) Younkwang Jung ) developer
.png)
